保持工作輥的上輥和下輥相對于軋機中心線對稱且在軸線方向上移動。這種的工作輥移動的設計，是用來改變工作輥和支撐輥的偏移需要大的移動量。這種大移動量的采用需要大量的改裝費用，并且需要解決很多問題.

The upper and lower rolls of the work roll are symmetrical and move in the direction of the axis of the rolling mill. The movement of this work roll is designed to change the shift of work rolls and support rolls to require large amounts of movement. The use of this large shift of momentum requires a lot of modification costs, and many problems need to be solved.

驅動電機斜置在鋸機底座上，通過傘齒輪及主傳動軸帶動鋸片，鋸片由液壓裝置鎖緊在傳動軸上。鋸片進鋸由液壓驅動，進鋸速度根據鋸切阻力由比例閥調節。當軋件斷面較大、鋸切阻力高時，進鋸速度慢，反之，進鋸速度塊。

The driving motor is inclined on the base of the saw machine, and the saw blade is driven through the bevel gear and the main drive shaft, and the saw blade is locked on the drive shaft by the hydraulic device. The sawing saw is driven by hydraulic pressure, and the speed of the saw is adjusted by the proportional valve according to the cutting resistance. When the section of the rolled piece is large and the cutting resistance is high, the speed of the saw is slow, and conversely, the speed block of the saw.

據說在14世紀歐洲就有軋機，但有記載的是1480年意大利人達·芬奇（Leonardo da Vinci）設計出軋機的草圖。1553年法國人布律列爾(Brulier)軋制出金和銀板材,用以制造錢幣。此后在西班牙、比利時和英國相繼出現軋機。

It is said that there are rolling mills in Europe in the fourteenth Century, but it is recorded that in 1480, Leonardo Da Vinci (Italian Italian designer Da Finch) designed the draft for rolling mills. In 1553 the French law Adler cloth (Brulier) rolled gold and silver plate, used in the manufacture of coins. Since then, rolling mills have been rolled out in Spain, Belgium and Britain.