合理的模具設計。在級進模中,下料順序的安排有可能影響到沖壓件成形的精度。針對沖壓件細小部位的下料，一般先安排較大面積之沖切下料，再安排較小面積的沖切下料，以減輕沖裁力對沖壓件成形的影響。

Reasonable mold design. In progressive die, the order of blanking sequence may affect the accuracy of stamping forming. In order to reduce the impact of punching parts, the punching and cutting blanking of small area is arranged in the light of the blanking of the small parts of the stamping parts.

手鋸加工方法

扁鋼的鋸削：在扁鋼鋸口處劃一周圈線，分別從寬面的兩端鋸下，兩鋸縫將要結接時，輕輕敲擊使之斷裂分離。這樣鋸削，而且能較好地防止鋸齒崩缺。反之若從窄面下鋸，非但不經濟，而且只有很少的鋸齒與工件接觸，工件越薄，鋸齒越容易被工件的棱邊鉤住而折斷。

Processing method of hand saw

Sawing of flat steel: a circular line at the cutting edge of flat steel, which is cut down from the two sides of the wide surface. When the two saws will be tied, it will be gently tapped and broken apart. The sawing efficiency is high, and the sawtooth collapse is prevented. On the , if it is sawed under the narrow face, it is not economical, and only a few teeth are touched with the workpiece. The thinner the workpiece is, the more easily the sawtooth is caught and broken by the edges and edges of the workpiece.

深縫：鋸削深縫時即當鋸縫的深度超過鋸弓高度時，高度時，鋸弓就會與工具相碰，無法繼續(xù)鋸削；此時應將鋸條拆出，將鋸條轉90。

Deep seam: when sawing deep seams, when the depth of the sawblade exceeds the height of the saw bow, when the height is high, the saw bow is touched by the tool and can not continue to be sawed; the saw strip should be removed and the saw blade is turned 90.